NEWS CENTER

新闻中心

  • 催化燃烧设备的制造工艺流程?
  • 本站编辑:杭州瑞茂环保技术有限公司发布日期:2022-02-17 15:57 浏览次数:

通过除尘阻火系统。然后进入换热器,再送到加热室,使气体达到燃烧反应温度,再通过催化床的作用,使有机废气分解成二氧化碳和水,再进入换热器与低温气体进行热交换,使进入的气体温度升高达到反应温度。

如达不到反应温度,加热系统科通过自控系统实现补偿加热。利用催化剂做中间体,使有机气体在较低的温度下,变成无害的水和二氧化碳气体。

产品性能特点:操作方便,设备工作时,实现自动控制,安全可靠。设备启动,仅需15~30分钟升温至起燃温度,能耗低。采用当今先进的贵.金.属.钯、铂浸渍的蜂窝状陶瓷载体催化剂,比表面积大,阻力小,净化率高。余热可返回烘道,降低原烘道中消耗功率;也可作其它方面的热源。使用寿命长,催化剂一般两年更换,并且载体可再生。

First, through the dust removal and fire suppression system. Then it enters the heat exchanger and then sent to the heating chamber to make the gas reach the combustion reaction temperature. Then, through the action of the catalytic bed, the organic waste gas is decomposed into carbon dioxide and water, and then enters the heat exchanger for heat exchange with the low-temperature gas to raise the temperature of the incoming gas to the reaction temperature.

If the reaction temperature cannot be reached, the heating system department realizes compensated heating through the automatic control system. The catalyst is used as an intermediate to turn the organic gas into harmless water and carbon dioxide gas at a lower temperature.

Product performance features: convenient operation, automatic control when the equipment is working, safe and reliable. When the equipment is started, it only takes 15 ~ 30 minutes to raise the temperature to the ignition temperature, with low energy consumption. Adopt today's advanced expensive Kim Genus The honeycomb ceramic supported catalyst impregnated with palladium and platinum has large specific surface area, low resistance and high purification rate. The waste heat can be returned to the drying channel to reduce the power consumption in the original drying channel; It can also be used as a heat source in other aspects. The service life is long, the catalyst is generally replaced in two years, and the carrier is renewable.